Three changes, all driven by a real project where a 4-digit 7-segment clock
was unreadable and half its parts were not actually seated.
Labels on hover only
--------------------
Eight vertical resistors at 19 px pitch rendered eight 93 px "Resistor 220 Ω"
labels on top of each other, hiding the parts and the breadboard holes; the
SPICE overlay added ~40 more `0uV` pills. Both are now revealed on hover:
hovering a part also lights up the voltages of every wire touching it.
The label is hidden with OPACITY and stays in flow. pinPositionCalculator
derives the rotation pivot from wrapper.offsetHeight, so taking it out of
flow would move the pins of every rotated component in every saved project.
Seat-on-drop
------------
The drag-time magnet only aligned the anchor pin and assumed the rest
followed, which is how parts ended up HALF-seated: some pins in holes, the
rest dead in the air. It looks mounted in a screenshot and silently breaks
the circuit. On release we now re-solve properly — nearest position where
EVERY pin is in a free hole, sliding past occupied columns — via the new
solvePlacement/seatOnDrop. Geometry comes from the element's own pinInfo,
so there is no part whitelist.
Sub-pitch translation
---------------------
solvePlacement first assigned pins to holes at half-pitch, then translates
by the centroid of the residuals before judging fit. Pinning the anchor dead
centre refused every off-lattice footprint: a diode spans 7.5 pitches, so
one leg landed 4.8 px out. Shifted 2.4 px, BOTH legs sit inside tolerance —
what bending the leads does on a real board. Measured over the catalog this
takes seatable parts from 87 to 125 of 152; diodes, transistors, regulators,
optocouplers and flip-flops are rescued with no artwork change.
Staying under SEAT_TOLERANCE (< half pitch) keeps each pin's nearest hole
unambiguous, so computeSeating resolves the same holes and the netlist is
unaffected by the small offset.
Also: refuse a placement that would put two of a part's own pins in one
strip. A column strip — and far worse, a power rail — is a single net, so
such a seating shorts the part to itself. Without it a 7-segment happily
lays its pins across a rail. And deduplicate pin names before solving:
calculatePinPosition resolves by name and returns the first match, so a
board carrying GND x5 collided with itself and was refused outright.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
66c6c7d813