Reporter feedback after 7aca3db: pressing Stop on the uno-7segment
example turned the 7-segment off, and pressing Start again left
random segments lit / no number at all. The previous fix made
resetPinStates() notify every listener with (pin, false) on both
Stop and Reset, which was right for Reset (full reboot) but wrong
for Stop:
- On Stop the AVR CPU is just paused. Internally it still has
PORTD=0xFF (or whatever the last drive was).
- resetPinStates blanked the pinStates cache + fan-out LOW
notifications. Display turns off, fine.
- On Start the CPU resumes from where it paused. avr8js's port
listener fires only for bits that CHANGED relative to its OWN
oldValue (which still holds the pre-stop value). If oldValue
matches the live register, no pinChange event fires for that
bit, and the display has no signal telling it to come back on.
Split the API into two methods:
resetPinStates() — soft cleanup, drops outputPins only. Used by
stopBoard. Cached pinStates and visual state
stay so the resume picks up where it left off.
hardResetPinStates() — full cleanup, drops outputPins + pinStates
and fan-outs (pin, false) to listeners.
Used by resetBoard (CPU starts at PC=0,
firmware re-drives every pin from setup()).
Updated the test helper clearAllPinManagerState to call
hardResetPinStates between tests so the same-state short-circuit in
triggerPinChange doesn't suppress fresh events.
All 32 vitest tests pass (AVRSimulator, interconnect-routing,
dual-arduino-software-serial, pin-position-rotation).
b2474bf5d1