The slide-switch SPICE model only wired pin 1 <-> pin 2 (an SPST), ignoring
pin 3. The part is really an SPDT whose common wiper (pin 2) selects pin 1 at
value=0 or pin 3 at value=1, so a switch wired GND-1 / signal-2 / VCC-3 (the
natural Wokwi hookup) could never pull its signal high. Fixes the reported
ESP32-C3 case (issue #247) where only the green LED lit and the switch never
toggled the red one.
Second cause on that board: the ESP32-C3-DevKitM-1 exposes its supply as
3V3.1/3V3.2 and 5V.1/5V.2 (there is no bare 3V3/5V pin). VCC_PIN_RE has no
numeric-suffix branch on purpose (a dual-supply pin such as L293D VCC2 must
not collapse onto the shared logic rail), so those numbered pins floated at
0 V and the switch's HIGH side was dead. List them in boardPinGroups for
esp32-c3 / esp32-s3 / esp32-cam.
- componentToSpice: SPDT emission (both throws, complementary 0.01/1e9 R).
- digitalGateEngine: both driveSwitch paths (all-digital + mixed) made SPDT to
match, so the pure-digital paint and the ngspice solve agree.
- examples-digital / examples-circuits: rewire every slide-switch so the rail
feeds pin 3 and pin 1 is the value=0 throw, preserving value=ON=HIGH.
- spice-slide-switch-spdt-repro test reproduces issue #247 at the netlist level.
Flip-flops are edge-triggered and hold state, which the combinational settle
kernel cannot model alone. buildDigitalNetwork now gives each flip-flop explicit
state + rising-CLK-edge detection (reusing the LogicGateParts sample semantics):
sample the data nets on the edge, drive Q + Qbar. Because a flip-flop only
updates on the clock edge, a Q->D / Q->CLK feedback (counter / shift register)
does not oscillate the settle loop. isAllDigital now accepts a gate OR a
flip-flop, so pure sequential circuits qualify.
Test digitalgate-sequential (4): D (capture + hold), T (toggle), JK
(hold/set/reset/toggle), and a 2-bit ripple counter (FF0.Qbar clocks FF1)
counting 1,2,3,0,1 - impossible on the SPICE path (no edge detection at DC, no
SPICE mapper). The controller already routes all-digital circuits through
buildDigitalNetwork, so a board-less counter/shift-register example would run
live; authoring those gallery examples is the only follow-up. Full digitalgate
+ examples-digital + circuit-simulation-service suites green (127 tests).
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
David Montero