CircuitSimulationService.handleMcuEdge(boardId, pinName, state, vcc)
runs the WASM alter + .op + extract path instead of rebuilding the
netlist. Cached `loadedContext` lets `publishFromLastResult` shape an
ElectricalSnapshot without re-running buildInputFromStore.
Coalesces with the canvas-change tick:
- If a full solve is in flight: edge is queued and replayed after
(so the netlist matches when alter runs).
- Last-edge-wins per pin: edges overwrite the same field, so a
10kHz toggle collapses to whatever was last seen at flush time.
connectMcuEdgesToService.ts wires PinManager.onPinChange events to
the service:
- Subscribes to every Arduino-pin slot (0..63) per board. Per-pin
listeners are no-cost when the pin never fires.
- Coalesces edges per pin in a 16 ms window before calling
handleMcuEdge (60 fps cap, well below per-solve cost of 5-15 ms).
- Re-subscribes when boards change (PinManager instances are
recreated by loadHex / setActiveBoard).
MixedModeSchedulerPort gains onMcuPinChange in the port interface
(was already on the singleton but missing from the contract).
3 new service tests cover:
- initial full solve + alter + republish on edge
- coalescing edges with in-flight full solves
- handleMcuEdge kicks a full tick when no circuit is loaded
11 service tests + 90-test regression suite pass. tsc clean.
Next: E — convergence helpers (.options gmin, op-amp retry) so the
LM358 subckt can finally be enabled in componentToSpice.ts.
Co-Authored-By: Claude Opus 4.7 (1M context) <noreply@anthropic.com>
The service is the single owner of the simulation loop. Replaces
the trio of wireElectricalSolver + connectLegacySolverToMixedMode +
connectMixedModeSchedulerToStore once G* lands.
Architecture:
- Depends on PORTS only — SimulatorStorePort, ElectricalStorePort,
MixedModeSchedulerPort. Zero coupling to useSimulatorStore /
useElectricalStore / WASM. Easy to test with fakes (and that's
what circuit-simulation-service.test.ts does).
- Single tick(): build netlist → load → solve → extract → publish.
Coalesces concurrent triggers so rapid store changes collapse to
one trailing solve.
- Domain ElectricalSnapshot type covers nodeVoltages + branchCurrents
+ pinNetMap + timeWaveforms + analysisMode + warnings. Shape
matches what the 12 existing useElectricalStore consumers read.
NetlistBuilder extension: BuildNetlistResult now reports `nets`
(every non-ground SPICE net) and `voltageSources` (every V card the
builder emitted). The service uses these to construct the full
vectorsOfInterest list — every node voltage + every branch current
— so the solver returns the data the legacy consumers want.
Scheduler addition: `setExtraVectorsOfInterest(vectors)` lets the
orchestrator add to the per-pin set. Branch currents (i(v_*))
flow through this hook.
8 service tests cover initial solve, branch current extraction,
re-solve on store change, no-spurious-solve, coalescing, .tran
waveforms, warnings forwarding, error-tolerance.
Next: C1+C2 — extract ADC injection / waveform replay into a
solver-agnostic module that just subscribes to useElectricalStore.
Co-Authored-By: Claude Opus 4.7 (1M context) <noreply@anthropic.com>
davidmonterocrespo24